3.17.1 Configuration
The section describes how to configure Loop Protection.
Web Interface
To configure the Loop Protection parameters in the web interface:
1. Click Configuration, Loop Protection, Configuration
2. Activate to select enable or disable the port loop Protection.
3. Click Apply to save the setting
4. If you want to cancel the setting then you need to click the Reset button. It will revert to previously saved values
Figure 3-17.1: The Loop Protection Configuration (GS-2310P)
Parameter description:
General Settings:
Enable Loop Protection:
Controls whether loop protections is enabled (as a whole).
Transmission Time:
The interval between each loop protection PDU sent on each port. valid values are 1 to 10 seconds.
Shutdown Time:
The period (in seconds) for which a port will be kept disabled in the event of a loop is detected (and the port action shuts
down the port). Valid values are 0 to 604800 seconds (7 days). A value of zero will keep a port disabled (until next device
restart).
Port Configuration:
Port:
The switch port number of the port
128
LANCOM GS-2310P/GS-2326(P) User Manual
3 Configuration
