C
C
B
9
Make sure, when removing the front panel, to pull
straight out. DO NOT bend plastic when removing the
panel, this could damage the retaining clips.
!
ATTENTION
A. Press Retaining Clip
A. Front Panel
B. Back Panel
C. Retaining Clips
A
A
6.
Press one of the top retaining clips, located on the inside
of the front panel, and simaltaneously pull forward on the
panel to unhook from the retaining clip. Repeat for
remaining three front retaining clips.
7. Slide the front panel off of the dispenser by leaning the top
of the panel forward then slide off of the dispenser.
8.
Route tubing from the CO
2
inlet at the remote chiller and
normal, non-diet syrup pumps and connect both lines to
one of the low pressure CO
2
regulator manifold outlets.
B
A
C
D
A. Line to Non-Diet Syrup
Pumps/Remote Chiller
B. Line to Diet Syrup
Pumps
C. Line to CO
2
Regulator
D. CO
2
Regulator Manifold
A. Carbonator Relief Valve
A
11. Verify all Bag-in-Box contain syrup and check for leaks.
12. Open the pressure relief valve located on the remote chiller
system by flipping up on the valve cap lever. Hold open
until water flows from the relief valve then close (flip down)
reflief valve.
The dispenser must be properly electrically grounded
to avoid serious injury or fatal electrical shock. The
power cord has a three-prong grounded plug. If a
three-hole grounded electrical outlet is not available,
use an approved method to ground the unit. Follow
all local electrical codes when making connections.
Each dispenser must have a separate electrical circuit.
Do not use extension cords. Do not connect multiple
electrical devices on the same outlet.
!
WARNING
13. Connect power cord to grounded electrical outlet.
14.
Turn on the power to the dispenser by flipping the power
switch, located underneath kickstand. (See previous page)
15. Unhook the kickstand and lower the head of the tower to
access the touchscreen.
16.
Once the screen has booted up, access the service menu
by placing your finger at the top, right corner of the screen.
17.
In one swift, fluid motion slide your finger along the top of
the screen to the left till you reach the upper left corner
of the screen, then hold your finger to the screen for a
minimum of two (2) seconds.
- Slide Finger to Left and Hold
9. Connect tubing routed from the diet syrup pumps to the
second outlet of the low pressure CO
2
regulator manifold.
10. Turn on the water supply.
