Parasol Installation Instructions
ADJUST THE SHADE (If Necessary)
- Raise the moving rail approximately 12” above the
bottom rail and check the level by measuring the
distance from the bottom rail to the moving rail on the
left and right sides. If the distances are not equal, you
must adjust the rail to level it.
- To adjust one side if necessary, remove the bottom
cover, loosen a locking collar on one side and slide the
leveling socket off the shaft. Adjust the moving rail on
the side where the leveling socket is off the drive shaft.
After the moving rail is level, slide the leveling socket
onto the drive gear shaft and tighten the locking collar.
- Operate the shade to verify the shade is level. Repeat
the above steps if necessary, and reinstall the bottom
rail cover.
TEST THE SHADE (If Necessary)
- Prior to installing the shade in the window, test its
operation.
- Press the manual control button on the bottom rail or
satellite eye to test the shade. Alternately lower, stop
and raise the shade.
- If you ordered a remote control, use the remote to test
the operation and verify that the side rails are
assembled correctly.
> Aim the remote at the sensor eye. Press and release
the UP button to make sure the shade moves up.
Press and release the DOWN button to make sure
shade moves down. If the shade moves opposite of
the command, dissemble and switch out the side rails.
- If you used the DC power supply to test the shade,
unplug the power supply until you are complete with the
installation.
CONNECT THE POWER SOURCE (Cont.)
DC Power Supply
- Remove the bottom rail cover and route the power
cable from the shade through the bottom left corner
bracket. Plug into the extenstion cable.
- Reinstall the bottom rail cover and plug the other end of
the extension cable into the DC power supply.
- Plug the DC power supply into a standard wall outlet.
The power supply may be oriented with the cable at the
top or bottom.
- Secure the power supply cable using wire retainers. If
hiding the cable behind the shade, make sure it does
not imped the operation of the shade.
- Space wire retainers approximately 15” apart along the
power supply cable.
-
Warning:
Keep cables and small parts out of the reach
of children.
-
Warning:
Electric shock and/or fire hazard may occur,
if not propery installed.
Power Cable
from Shade
Extension
Cable
DC
Power
Supply
15"
Maximum
Wire Retainers
