Lafayette Parasol Accu-Rise, Руководство по установке

Страница: 26 / 83

Parasol Installation Instructions BACK
LEVEL THE BOTTOM RAIL (If Necessary)
- Lift the bottom rail to locate the pockets on the
underside of the rail.
- Gently pull down on the bottom rail to fully insert the
7/64” allen wrench key into the pocket. The key is fully
inserted when the ring on the key abuts to the pocket.
- Lift up on the bottom rail slightly before turning the Allen
wrench key. Turn the key clockwise to raise that side of
the bottom rail, or counter-clockwise to lower it.
- One quarter turn of the key equals approximately 1/4”.
- Adjust the end pockets first. Then adjust any additional
pockets as necessary to maintain equal tension across
the bottom rail.
Pocket
Underside of Bottom Rail
Allen
Wrench
Key
Lower
Raise
REMOVE THE SHADE (If Necessary)
- Lower the shade approximately 4”.
- While holding the headrail, push back on the bottom tab
of the installation bracket to release the bottom edge of
the headrail.
- After releasing the bottom edge, roll the back of the
headrail down and out from the bracket.
CARE AND CLEANING
Regular light dusting with a feather duster is all the
cleaning that is needed in most circumstances. For
deeper cleaning, vacuum gently with a soft brush
attachment. Do not vacuum Triple cell fabrics.
Bottom
Tab
Back of
Shade
Headrail
Bracket
INSTALL OPTIONAL HOLD-DOWNS
-
Lower the shade and place the pins from the hold-down
brackets into the end caps on the bottom rail.
- On the mounting surface, mark the bracket hole
locations.
- Check that the brackets are level and attach them to
the mounting surface using two screws.
For Monaco and Riviera Materials
Adjust the Shade Height (If Necessary)
If the shade height needs adjusted or the bottom rail is
not level, the cord on the underside of the bottom rail may
need adjusting.
If the Ferrule comes off the cord
Once you are satisfied with the shade height make sure
the Ferrule is properly seated back in the pocket and tuck
away any extra cord.
Pull the Ferrule out of the pocket
in the Bottom Rail by pulling on
the cord
(if there is not enough to pull
with your fingers you may need
to use needle nose pliers)
Loosen the cord on the Ferrule
so that you have room to slide it
up and down
To raise the bottom rail, slide the
Ferrule up on the cord by small
amounts
To lower the bottom rail, slide
the Ferrule down on the cord by
small amounts
Thread the cord through the
Ferrule and loop it around
making sure that the cord ends
up in the groove on the side of
the Ferrule to ensure a proper
fit.