La San Marco NEW 105 3, Использование и обслуживание

Страница: 33 / 160

32
En
G
li
SH
Figure 3 Figure 4
eXTeRNAL PUMP (OPTIONAL)
1) Use the pipe
a (900 mm, provided with the machine) to connect the cut-off valve of the mains to the tap
1 for water inlet to the water softener (figure 5).
2) Connect pipe c (600 mm, provided with the external pump) to the pump suction with tap 2 of the water
softener (figures 6-7).
3) Connect pipe d (of the water system of the coffee machine) to the pump delivery (figure 7).
Figure 5 Figure 6 Figure 7
3.4 Drain line
Connect the drainage tube to the grounds collecting tray and to the water drainage system.
3.5 electrical connection
Instructions for a proper electrical connection of the espresso coffee machine:
• Before connecting the unit to the electrical mains, make sure that the data on the data
plate corresponds to the electrical mains.
• The tag is located on the left side of the machine (and can be accessed by removing the
lower tray).
• The electrical system provided by the client must comply with current standards. The
power socket must be equipped with a working earth connection. LA SAN MARCO
SPA will not in any way be held liable if legal requirements are not met. An improper in-
stallation can cause injury or damage for which the manufacturer cannot be held liable.
• For the electrical connection, it is necessary to install an omnipolar main switch upstre-
am of the power supply; this switch should be rated according to the electrical cha-
racteristics (power and voltage) shown on the rating tag. The omnipolar switch must
disconnect the power supply with a contact gap of at least 3 mm.
• If it is necessary to use adapters, multiple plugs and extensions, only products meeting
applicable safety standards must be used.
• To avoid any overheating of the power cable, unwind it completely.
Connect the power cord to the electrical mains as shown in the attached diagram:
a 1 b 2
a 1 b 2
b c