KUHN GMD 600 G II, Руководство по сборке и эксплуатации

Страница: 37 / 48

- 35 -
2. CUTTERBAR
Note : Make sure the cutterbar is in the vertical position
when checking, adding or changing oil.
The oil level is at its maximum when oil flows out of the
filler plug hole.
Check oil level once a day. Add SAE 80 W EP (GL4)
oil to the cutterbar at filler plug (D) (photo 48).
To drain oil, remove magnetic drain plug (E) (photo 48)
located underneath the cutterbar below the bevel
gearbox.
Clean all metal particles off the magnetic drain plug
before refitting.
NOTE : Provided above intructions are strictly observed,
there is no cause for alarm if it is found that the
transmission case is very hot to touch, provided that
the discs turn freely by hand. .
Attention : Before carrying out this check, turn off
the tractor engine, remove ignition key and dis-
connect the PTO shaft.
3. PTO SHAFT
Lubricate the PTO shaft at the hourly intervals indicated
in figure 49 with SHELL Multi-Purpose grease NlGI
grade 2.
The recommended grease and oil change periods are based on normal field and work
conditions.
Severe or unusual conditions may require more frequent lubrication or oil changes.
RESPECT SPECIFIED OIL QUANTITIES AND GRADES : SAE 80 W EP (GL4) OIL ONLY.
4. GREASE FITTINGS
Clean fittings before applying grease. Oil all pivot and linkage points every fifty hours.
Grease breakaway sliding components as required.
49
48
[In certain countries SAE 80 W EP (GL4) oil may not be available. In this case a GL4 or GL5 grade
SAE 80 W 90 oil may be used as a replacement. Never use a straight EP 90 oil].