KUHN GMD 600 G II, Руководство по сборке и эксплуатации

Страница: 22 / 48

- 20 -
Adjustment of chassis height from the
ground
1. For tractors equipped with hydraulic position
control function :
- On a level surface lower the 3-point lift until the stop
plate (G) engages in its housing and clears the rear
wall by a small gap such as "X" = 3 mm / 0.1" as
shown in photo 18.
- After having adjusted the chassis’ height, move the
stop against the 3-point lift control lever so that the
3-point lift lowers itself at the same depth each time
(photo 19).
2. For tractors not equipped with hydraulic posi-
tion control function the stop-chain delivered with
the machine must be used.
- Connect stop-chain (D) with its hook (G) supplied in
the hardware kit of the machine to one of the free
holes at the tractor’s top link attachment clevis.
- Lower the machine into working position until the
stop plate (G) engages in its housing (photo 18) and
the stop chain (D) is tight (photo 20).The stop plate
should then clear the rear housing wall by a small
gap such as "X" = 3 mm / 0.1" (photo 18). The 3-
point frame height is correct when :
- The cutterbar is resting on the ground.
- The stop plate is engaged in its housing (clear-
ance "X" being approximately 3 mm / 0.1")
- Stop-chain (D) is tight.
- To keep this adjustment permanently, close hook
eyelet (S) with roll pin (dia. 5 x 45 mm).
2 0
1 9
1 8