KUHN GMD 600 G II, Руководство по сборке и эксплуатации

Страница: 36 / 48

- 34 -
It is forbidden to discard oil, grease or filters of any type. These must be given to specialised
waste disposal organisations to protect the environment.
IMPORTANT
Imperatively change oil in : - cutterbar bevel gearbox
- cutterbar
after the first 10 hours of use [SAE 80 W EP (GL4)].
Thereafter, oil must be changed every 200 hours of work and at least once per year.
NOTE : Before draining oil, operate the cutterbar for a few minutes so that oil warms up.
LUBRICATION
GMD 600 G
II
GMD 700 G
II
GMD 800 G
II
GMD 600 G
II
- HD GMD 700 G
II
- HD GMD 800 G
II
- HD
Quantity of oil in the bevel 0.45 litre / 1 US pint 0.45 litre / 1 US pint 0.45 litre / 1 US pint
gearbox [SAE 80 W EP (GL4)] 0.75 Imp. pint 0.75 Imp. pint 0.75 Imp. pint
Quantity of oil in the cutterbar 2 litres/4.25 US pints 2 litres/4.25 US pints 2.25 litres/4.75 US pints
[SAE 80 W EP (GL4)] 3.5 Imp.pints 3.5 Imp.pints 4 Imp.pints
1. BEVEL GEARBOX
Plug (C) (photo 47) serves as a check plug when the
bar is horizontal. Remove plug (C). When oil level is
at its maximum, it will just begin to flow out of the hole.
Check oil level once a day. Add oil through filler plug (B)
(photo 47) if required.
The pressure relief valve (A) (photo 47) must be
checked and cleaned regularly. The ball detent must
be free to relieve pressure.
The maximum oil capacity of this gearbox is as shown
in the table below and it is important not to exceed
this quantity.
Plug (C) is also used as a drain plug when the
cutterbar is in the vertical transport position.
47