KUHN GMD 600 G II, Руководство по сборке и эксплуатации

Страница: 17 / 48

- 15 -
- Fix the inner deflector shield (S) (photo 8 A) using 3
cup square bolts (T) (M 10 x 20), 3 plain washers
(diameter 11 x 24 x 2) and 3 self locking nuts (M 10).
To assemble the shield (S) easily, install all of the
bolts (T) into place before tightening them.
The angular position of the swath wheel compared to the cutterbar can be adapted to working conditions
enabling a regular flow of the cut crop towards the rear.
Position the swath wheel so that maximum angle (A') (fig. 9 A) is obtained. In difficult working
conditions (long, dense, bent over crops) position it towards minimum angle (A) (fig. 9 A).
7. Installing outer disc with cone and outer swath wheel
- Attach the outer disc with cone using 4 hexagon
screws (M 12 x 20), 4 spring washers (conical centre
part towards the top) and, if necessary, a shim plate
(code 568 071 00) (see page 29, fig. 2), so that its
largest diameter is positioned at a right angle in
relation to the adjacent disc (see pictorial opposite).
Tighten to 12 daNm (90 ft.lbs).
- Attach swath wheel assembly (U) to outer skid shoe
(photo 9) with 2 cup square bolts (V) (M 12 x 35), 2
conical washers (dia. 13 mm) and 2 self-locking nuts
(M 12).
Torque : 8.5 daNm/65 ft.lbs
Before tightening screws (V), make sure that swath
wheel does not come into contact with cone cover or
knives.
Keep to a distance of X = 15 to 25 mm / 5/8" - 1".
8A
9A
9