KUHN GMD 600 G II, Руководство по сборке и эксплуатации

Страница: 16 / 48

- 14 -
5° Installing pivoting lever, lift rod, connecting plate, cord and hydraulic hose
- Install pivoting lever (A) on pin (B) and secure with a
roll pin (dia 6 x 36) (photo 6)
- Install lift rod (N) (photo 6) on pin (0) and secure with
a roll pin (dia 6 x 36).
- Connect lift rod (N) and the cylinder rod connecting
plate ( C ) to the pivoting lever (A) with pin (Q) and 2
roll pins (dia 6 x 30) as shown in photo 6.
- Thread cord (D) through the eyelet (E), then attach
the metallic hook (X) to stop plate (G) and close the
hook's eyelet with a pair of pliers. This cord is factory
installed on transport latch (F) (photo 6 A).
- Thread cord (D') through eyelet (E') and through the
eyelet of transport latch (F) which already houses
cord (D). Then tie a knot (Y) to the loose end of cord
(D') (photo 6 A).
- Fix hose (Z) to cylinder using a hollow screw and a
copper washer on each side of the banjo joint (photo
6 A).
6° Compensating spring, inner shoe and inner swath board assembly
- Connect compensating spring (P) (photo 7) to axle
(R) of frame pipe and secure with 2 roll pins (dia.
8 x 40).
This operation is carried out easily by attaching the
machine to a tractor and raising the cutterbar until
the spring mounting hole lines up with pin (R).
- Fit inner shoe (I) by means of 4 cup square bolts (J)
(M 10 x 25) and 4 self locking nuts (M 10) (photo 8).
If it becomes necessary to transport the
machine on a trailer after assembly, the
compensating spring should not be
connected at this stage, thus allowing
the frame to rest securely on its left skid.
6
6A
7 8