KUHN GMD 600 G II, Руководство по сборке и эксплуатации

Страница: 28 / 48

- 26 -
SAFETY BREAK-AWAY
The factory setting of the latch is adapted to most working conditions.
The stack of spring washers (A) should be compressed to Y = 95 mm (3 3/4") (fig. 3 and photo 34). Observe spring-
washer arrangement in fig. 3 carefully.
If after resetting, the cutterbar continues to break away, the pressure of spring assembly (A) (photo 34) can be
increased, but in all cases stacking must not be less than 91 mm (3 2/3"), as otherwise safety disengagement cannot
function.
NOTE : Before using the mower, the break-away linkage must be checked for good operation making sure all
components slide correctly and are well greased. Check for any cutterbar damage if an obstruction is
encountered.
A breakaway latch allows the cutterbar to swing back
if an obstruction is hit (photo 33).
IF THE LATCH RELEASES, STOP THE TRACTOR
IMMEDIATELY AND DISENGAGE THE PTO.
To reset the cutterbar, back the mower until the
cutterbar is in its normal position.
3 3
3 4
3