KUHN GMD 600 G II, Руководство по сборке и эксплуатации

Страница: 40 / 48

- 38 -
Before assembling the inner swath board, the mounting
bracket (B) must be welded on the cutterbar stiffener
(M) following the instructions on figures 53 and 54.
GMD 600
GII
: X = 430 mm
GMD 700
GII
: X = 720 mm.
Fit the inner swath board support plate (A) on the
mounting bracket (B) with 3 cup square bolts (V)
(M 12 x 30) and 3 self locking nuts (O) (M 12) (torque:
8 daNm / 60 ft.lbs) (figure 53).
Next fit the inner swath board (C) on the support (A) by
means of a cup square bolt (J) (M 12 x 80), a pressure
spring (R), a dished washer (S) and a self-locking nut
(T) (M 12) (figure 53). Do not overtighten the nut so that
the board (C) can oscillate around the fixing bolt (J).
To finish the job, fix the swathing stick (D) on the plate
(C) with 2 cup square bolts (E) (M 8 x 50) and (F) (M
8 x 30), a spacer (G) and 2 self-locking nuts (H) (M 8)
(figure 53).
6. Lengthened left hitch pin
(kit No. 568 207 00)
For offsetting the machine up to 200 mm (8") a
lengthened hitch pin (T) (photo 55) can be mounted
on the left arm of the 3-point frame (looking in the
direction of travel).
Installation : see page 17.
7. Raised skids (fig. 56)
(kit No. 103 6230)
A raised skid shoe kit comprising 2 raised skids is
available as an optional equipment. This kit serves 2
purposes :
- providing a cutting height adjustable between
35 mm and 90 mm (1.5" and 3.5"),
- operating on sticky grounds.
This 2 raised skids are installed instead of the 2
regular end skids.
5 6
5 4
5 5