KUHN GMD 600 G II, Руководство по сборке и эксплуатации

Страница: 23 / 48

- 21 -
P.T.O. SHAFT
Connect the PTO shaft to the 540 rpm (min -1 ) tractor drive (with the free wheel fitted on the machine side).
Make sure PTO length is correct :
1° When the PTO is in its maximum extended position, a minimum tube overlap of 250 mm (10") must be maintained.
2° When the PTO is in its maximum overlap position (retracted), tubes should not butt against the yokes. As a safety
measure a clearance of at least 10 mm (2/5") must be maintained (fig. 21). If this is not the case, shorten the
two transmission tubes and the two guard tubes by the same length (fig. 22 and 23). Bevel and clean the tubes
(fig. 24) and grease the inside of the outer tube (fig. 25).
3° Never operate the PTO at too great an angle (X = +/- 30° maximum) (fig. A).
These recommendations and adjustments must be respected to avoid damage or premature wear of
the PTO.
Never connect the PTO to the 750 or 1000 rpm (min -1 ) tractor drive.
A
2 5
2 4
2 1
2 2
2 3
B
To avoid accidents which could be
serious, make sure that the guards
are always correctly in place and
secured with the safety chains. On
machine side attach the safety chain
to the main frame (photo B). Worn or
damaged guards should be replaced
immediately.