Kubota M9540, Руководство по ремонту, Страница: 310 / 619

3-S66
M8540, M9540, WSM TRANSMISSION
6. SERVICING
[1] BEARING, SHIFT FORK AND SYNCHRONIZER
Ball Bearing
1. Hold the inner race, push and pull the outer race in all directions
to check for wear and roughness.
2. Apply transmission fluid to the bearing, and hold the inner race.
Then, turn the outer race to check rotation.
3. If there is any defect, replace it.
W1024200
Needle Bearing and Thrust Needle Bearing
1. Check the needle bearing for abrasion, color change or other
damage.
2. If there is any doubt as to the condition of a needle bearing,
replace it.
W1070684
Taper Roller Bearing
1. Check the bearing for abrasion, color change or other damage.
2. If there is any doubt as to the condition of a taper roller bearing,
replace it.
W1070816
Clearance between Shift Fork and Shifter Groove
1. Measure the width of shift fork.
2. Measure the shifter groove width, and calculate the clearance.
3. If the clearance exceeds the allowable limit, replace them.
W1025154
Checking Contact between Coupling and Shifter
1. Check to see if there is flaw or wear on the spline of the coupling
and shifter, and the key groove on the coupling.
2. Engage the shifter with the coupling, and check that they slide
smoothly.
3. Similarly, check that there is any flaw or wear on the gear splines.
4. If there is any defect, replace them.
W1025396
Clearance between shift
fork and shift groove for
main change section
and range section
Factory spec.
0.15 to 0.40 mm
0.0059 to 0.0157 in.
Allowable limit
0.80 mm
0.031 in.
KiSC issued 09, 2008 A