Kubota M9540, Руководство по ремонту

Страница: 22 / 619

G-3
M8540, M9540, WSM G GENERAL
[2] E3 ENGINE
[Example : Engine Model Name V3800- E3 ]
The emission controls previously implemented in various countries to prevent air pollution will be stepped up as
Non-Road Emission Standards continue to change. The timing or applicable date of the specific Non-Road Emission
regulations depends on the engine output classification.
Over the past several years, Kubota has been supplying diesel engines that comply with regulations in the
respective countries affected by Non-Road Emission regulations. For Kubota Engines, E3 will be the designation that
identifies engine models affected by the next emission phase (See the table below).
When servicing or repairing ###-E3 series engines, use only replacement parts for that specific E3 engine,
designated by the appropriate E3 Kubota Parts List and perform all maintenance services listed in the appropriate
Kubota Operator's Manual or in the appropriate E3 Kubota Workshop Manual. Use of incorrect replacement parts or
replacement parts from other emission level engines (for example: E2 engines), may result in emission levels out of
compliance with the original E3 design and EPA or other applicable regulations.Please refer to the emission label
located on the engine head cover to identify Output classification and Emission Control Information. E3 engines are
identified with “ET” at the end of the Model designation, on the US EPA label. Please note : E3 is not marked on the
engine.
W1031971
[3] CYLINDER NUMBER
The cylinder numbers of kubota diesel engine are designated as
shown in the figure.
The sequence of cylinder numbers is given as No.1, No.2, No.3
and No.4 starting from the gear case side.
W1011077
Category (1) Engine output classification EU regulation
K From 19 to less than 37 kW STAGE
ΙΙΙ
A
J From 37 to less than 75 kW STAGE
ΙΙΙ
A
I From 75 to less than 130 kW STAGE
ΙΙΙ
A
Category (2) Engine output classification EPA regulation
ET
Less than 19kW Tier 4
From 19 to less than 56 kW Interim Tier 4
From 56 to less than 75 kW Tier 3
From 75 to less than 130 kW Tier 3
(1) EU regulation engine output classification category
(2) “E3” engines are identified with “ET” at the end of the Model designation, on the
US EPA label.
“E3” designates Tier 3 and some Interim Tier 4 / Tier 4 models, depending on
engine output classification.
KiSC issued 09, 2008 A