Settings
202
Pos: 34.41 /BA/Einstellungen/Großpackenpresse/Nadeleinstellungen/Position Nadeln – Preßkolben prüfen (2013-02-28 14:16:22) @ 107\mod_1334130303715_78.docx @ 962042 @ @ 1
11.4
Checking / adjusting position of needles – baling ram
a
a
b
Fig. 139
Check:
•
Completely release spring tension of the needle yoke brake
•
Manually actuate the tying process while the machine is at a standstill
•
Manually rotate flywheel mass until the needle points (1) have reached the upper edge
(b) of the fixed retainers (3) in the bale channel floor
•
Block the needles in this position and apply the flywheel brake
•
The dimension “a” (baling ram front edge to needle tip) must be 60 – 90 mm
If this is not the case:
Note
Set dimension "a" only in baling direction of the baling ram (2) (see arrow in fig.).
•
Remove drive cardan shaft from the knotter gear
•
Manually rotate flywheel mass (baling ram moves in baling direction) until dimension
a = 60 – 90 mm
•
Attach drive cardan shaft to the knotter shaft and secure
•
Manually actuate the tying process again while the machine is at a standstill
•
Check position of needles – baling ram again
•
Set spring tension of the needle yoke brake
Pos: 34.42 /BA/---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0.docx @ 4165 @ 3 @ 1
Содержание Big Pack 4x4
Страница 331: ......
