8
WARNING
Stand-off components are shipped in a flat state. The top and the back stand-off brackets must be formed and installed prior to
positioning the fireplace into a framed opening, in order to provide clearances from the appliance to combustible material.
Top stand-offs provide 5-3/4 in. (146 mm) minimum clearance to header. Use only non-combustible material in this area for the entire
width of fireplace. Do not use wood, sheetrock, etc. in this zone. Other clearances apply. All clearances must be maintained.
1. Remove and save the (4) screws securing the secondary stand-off heat shield and the top stand-off brackets, located on the top of the
fireplace.
2. Form the top stand-off brackets as shown, then re-attach to the fireplace using screws previously removed, along with (4) screws provided
in the fireplace components packet.
3. Form secondary heat shield and attach to top stand-off brackets using (4) screws provided in the fireplace component packet.
4. Form the top stand-off upper heat shield as shown, and attach to top stand-off brackets with the (4) screws provided in the fireplace
component packet.
5. Form back stand-offs and secure to fireplace back with provided screws.
3.0
FIREPLACE PREPARATION
3.1
Stand-Off Assembly and Installation
Figure 3.1, Stand-off Assembly and Installation Diagram
