34
15.0
SYSTEM OPERATION
15.2
Initialize the Control System for the First Time
1. Set ON/OFF rocker switch to OFF position on the IFC Control Module.
2. Install 4 AA batteries (included in components packet) into battery backup holder on the control module.
3. Connect the IFC Control Module to an AC power supply.
4. Install 3 AAA batteries (included in components packet) into the remote control battery bay, located at the base of remote
control.
Remove all packaging / combustible material from fireplace before initializing the control system.
NOTE:
Performing the next step will initiate pilot start-up in manual mode,
where the pilot igniter will spark repeatedly. The pilot will ignite if gas is supplied to
the fireplace.
1. Press the red SW1 button on IFC control module until the module beeps three
(3) times, and/or an amber LED is illuminated, indicating the IFC control
module is ready to synchronize with the remote control. See Figure 15.1.
2. Within five (5) seconds, push the remote control
ON/OFF
button. The IFC
control module will beep four (4) times to indicate the remote control’s
command is accepted, and is set to the particular code of that remote control.
3. Press the remote control
ON/OFF
button again. The pilot will shut down
indicating the remote has taken over. The system is now initialized.
4. Set the ON/OFF rocker switch to ON position to operate fireplace with the
remote control.
SW1 Button
LEDs
Figure 15.1, IFC Control Module
1. With the system ON, press the remote control
ON/OFF
key to turn OFF the appliance.
2. The remote control will only show room temperature and its icon on the LCD screen display, and the IFC control module
will be commanded to turn off the burner.
NOTE: See 15.12, Continuous Pilot / Intermittent Pilot (CPI / IPI), on page 37.
A single ‘beep’ from the IFC control module will confirm reception of the command.
1. With the system in
OFF
position, press
thermostat key
and
mode key
at the
same time to change from degrees °F to degrees °C.
2. Look at the remote control LCD screen to verify that °C or °F is visible on right
side of Room Temperature display.
15.3
Adjust Temperature Display
15.4
Turn ON the Appliance
Figure 15.2, Temperature Locations
15.1
Prepare Components
15.5
Turn OFF the Appliance
1. Starting from OFF, press the remote control
ON/OFF
key to turn ON the appliance.
2. The remote control will show all active icons on the LCD screen display, and the IFC control module will be commanded to
start the ignition sequence. Refer to 15.15, Control Module Ignition Sequence, on page 37.
A single ‘beep’ from the IFC control module will confirm reception of the command.
