Kolver 035001, Руководство пользователя

Страница: 30 / 64

Vers. 291020
30
Input/Output CN3 Connector:
PIN NAME FUNCTION
INPUT 24V
1 NOT USED
2 NOT USED
3 BIT1 SEQ Less significant weight bit to enable the Sequence (see the chart below)
4 BIT2 SEQ
5 BIT3 SEQ More significant weight bit to enable the Sequence (see the chart below)
6 BIT1 PR Less significant weight bit to enable Program (see the chart below)
7 BIT2 PR
8 BIT3 PR
9 BIT4 PR
10 BIT5 PR
11 BIT6 PR More significant weight bit to enable Program (see the chart below)
12 NOT USED
13 STOP MOTOR
Remote motor stop. If it’s activated the message “STOP MOTOR ON”
appears on the display. The motor will stop and won’t re-start working as
long as the signal stays active.
14 START Remote start with torque control screwing function.
15 REVERSE
Remote motor reverse with torque control "unscrewing" function. The
operating mode changes depending on how the REV BUTTON mode on
SETTING menu. The remote reverse input behaves exactly like the manual
reverse button on the screwdriver (see REV. BUTTON function).
16 IN ANG
External input for making the control unit start to count the angle. To be
used only if the function is active (see TORQUE & ANGLE function,
STARTING AT).
17 MISSING PIECE
If enabled it stops the motor, enables the error signal and “Error missing
piece” is displayed on the status bar.
18 IN RST
REMOTE RESET (see RESET TYPE on SETTINGS menu). If enabled it
resets screw, program or sequence depending on the pre-set mode.