Kolver 035001, Руководство пользователя

Страница: 7 / 64

Vers. 291020
7
At this point select a different program by clicking on the "Access to the menu" button or modify
the parameter out of range.
The error messages can be the following:
TorqueTargOverMax Target torque higher than the allowed limit for the screwdriver.
SpeedTargOverMax Target speed higher than the limit allowed for the screwdriver.
SpeedTargUnderMin Target speed less than the limit allowed for the screwdriver (50
RPM).
DownshiftTorqueOverTarg The fast phase torque setting is higher than the final target torque.
DownshiftSpeedOverMax The speed of the slow phase of this program is higher than the
maximum allowed by the screwdriver.
DownshiftSpeedUnderMin The speed of the slow phase of this program is less than the
minimum allowed by the screwdriver (50 RPM).
TorqueMaxOverMaxLim In angle control: the maximum torque set in the program is above
the limit of the screwdriver.
In torque control: the maximum torque set in the program is higher
than 20Nm.
TorqueMaxUnderMinLim In angle control: the maximum torque set in the program is equal or
lower than the minimum limit of the screwdriver.
In torque control: The maximum torque set in the program is equal
or lower than the target torque already set.
TorqueMinOverMaxLim In angle control: the minimum torque set in the program is equal or
higher than the maximum torque already set.
In torque control: the minimum torque set in the program is equal or
higher than the target torque already set.
RevTorqueOverMax The reverse torque of this program is higher than the maximum
torque of the screwdriver.
RevSpeedOverMax The reverse speed is higher than the maximum allowed by the
screwdriver.
RevSpeedUnderMin The reverse speed is lower than the minimum allowed by the
screwdriver (50 RPM).
If the connection with the motor control board is successful the following screen will be displayed: