Kolver 035001, Руководство пользователя

Страница: 37 / 64

Vers. 291020
37
SERIAL PRINT:
Every control unit is supplied with a 9 pin serial female connector (connection pin: PIN 2 = TX, PIN 3 =
RX, PIN 5 = GND) and a mini USB connector. You can print the results of each screwing on a printer (for
example Kolver model PRNTR1) and/or on PC (for example through Hyper Terminal or Realterm or any
data transmission program or EDU K-EXPAND). You can also save those results on a USB device.
The transmission characteristics (only serial and USB) are the following: 9600 (bits per second), 8 (data
bits), n (no parity), 1 (bits stop 1).
The print string is the following:
BARCODE RESULT
PROGRAM
NUMBER
MODEL SERIAL # TARGET
SCREWING
TIME
SPEED
BC:
7612320103052
OK PR:8 KDS-PL10 s/n 1819357
TARGET:
2.00Nm
ST:1.23s S:600
SCREW
NUMBERS
SEQUENCE STAGE TORQUE ANGLE DATE HOUR NOTE
Screw: 1/8 Seq: A 1/1 T: 1,99Nm A: 114deg 18/01/18 17.44.50
Example:
BC: 7612320103052 OK PR: 8 KDS-PL10 s/n: 1814914 TARGET: 2.0Nm ST: 1.23 S:600rpm Screw:1/8
Seq: A 1/1 T: 1.99Nm A: 114deg 18/01/18 17.44.50
BC: Codice barcode = it begins with “BC:” and it’s followed by the code of the scanned product.
Result = screwing result: correct or incorrect.
OK = the torque has been correctly reached, all the selected parameters are satisfied.
NOK = the torque has been reached during ramp time, under min time…
PR: Program Number = it indicates the running program.
Model = Model of screwdriver you’re using.
Serial # = serial number of the screwdriver that the unit has recognized.
Target = pre-set torque value
S: Speed = pre-set final speed.
ST: Screwing time = it indicates the time of the screwing.
Screw: Screw numbers = number of tightened screws/total number of screws.
Seq: Sequence and Sequence Stage = it indicates the sequence and stage of the sequence
T: Torque = torque value.
A: Angle = angle value.
Date = date
Hour = hour
Note = in case of end of program, it will be printed “Program end”; in the case of a sequence ended
"Sequence end". Or it indicates the type of error found or the correct screw mode.