Koden KGP-920, Руководство по эксплуатации

Страница: 92 / 132

Chapter 8 KGP-920
Setup Procedure
8-20 93121662-00
8.7 Initialization
(Displaying the menu)
Turn power on, then press the ENT key while the screen message
" CHECK OK " is displayed.
(How to use menus)
Initialization
1) Press [ 1 ] key to select “ 1:INITIALIZE ”.
2) Press [ ENT ] key. Menu is initialized and the screen for powering
off will appear.
or
Press [ CLR ] key. Initialization will be canceled
.
Other menu
(1) Press [ 2 ] to [ 6 ] key to select a desired item.
(2) Press [ ] or [ ] key to select a desired content.
(3) Press [ ENT ] key.
(Exit from the menu)
Press the [ MODE] key to display the screen for powering off.
8.7.1 Initialization
If your GPS position has failed due to satellite maintenance or other reason,
initialize your GPS navigator. Then, set all system parameters again.
8.7.2 Erasing entire data from memory
You can erase the entire data such as waypoints, events, MOB, and route
from memory.
8.7.3 Switching between Loran C LOPs, Loran A LOPs and Decca LOPs
initial setup: LORAN C
This menu option allows you to select a desired display among the loran C LOP,
Loran A LOP and Decca LOP.
8.7.4 Changing a storing method for present position (EVENT)
initial setup: AUTO
You can use either of the following two procedures for registering your current position (event).
AUTO: Pressing the EVT key automatically registers the points starting from No. 001
through 199. When the 200th point is reached, the number is returned to 001 again
and the older data is sequentially replaced by the newer one.
NOTE: Already registered data on the waypoints, events, MOBs and routes
remain unchanged.
NOTE: Already registered data on the waypoints, events, MOBs and routes
remain unchanged.