32
WARNING:
Be extremely careful when removing the lamp module. In the unlikely event that the bulb
ruptures, small glass fragments may be generated. The lamp module is designed to contain these
fragments, but use caution when removing the lamp module.
4. Loosen the two non-removable screws on the outside of the module (Figure 40).
CAUTION:
Never operate the projector with the lamp door open or removed. This disrupts the airflow
and causes the projector to overheat.
Figure 40:
Loosening the screws on the lamp module
5. Lift and grasp the metal bail wire and
lift the module out (Figure 41).
Dispose of the lamp module in an
environmentally proper manner.
WARNING:
Do not drop the lamp module or
touch the glass bulb! The glass may shatter
and cause injury.
Figure 41
: Removing the lamp module
6. Install the new lamp module, being
sure to align the connectors properly.
7. Push the module in until it is flush with the bottom case of the projector.
8. Tighten the screws on the outside of the module.
9. Replace the lamp door by inserting the hooks on the lamp door into the slots on the projector
and pressing the lamp door into place. The arrow on the lamp door should point to the lock
icon on the bottom of the projector. If the lamp door does not fit properly or bulges out, remove
the door and re-seat the lamp module.
10. Plug in the power cord and press the green
power
button to turn the projector back on.
11. To reset the lamp hour counter in the Status window, press and hold the
volume -
button, then
press the
source
button (while still holding down the
volume -
button) for 5 seconds. Verify that
the counter was reset by viewing the counter in the Status window.
