Suspension Arm Systems Independant
82
Revision 1
Mounting the rear plates
•
Place the 2 rear plate halves (spring side, recognizable by the two recesses
)
around
the spring arm. Please note:
•
To latch the two plate halves place them inside each other and slide together in the
direction of the arrow as seen in the illustration.
The plate halves latch into each other and become connected.
Make sure the plate halves are safely in place:
•
All latches on the plate halves must be securely latched.
Mounting the front plates
•
Repeat the process for the two front plate halves .
7.9.5
Mounting the Side Cladding on the Spring Arm
The illustration shows the spring arm
. The mounting process for the extension arm with
spring arm
is identical.
For reasons of simplification, the illustration shows the spring arm
without cables.
•
Attach the first side cladding and insert
3 plastic pins into the holes on the
spring arm.
The plate must snap into the guide of
the side cladding .
•
Attach the second side cladding and insert
3 plastic pins into the holes on the
spring arm.
The plate must snap into the guide of
the side cladding and latch the locks
of the two side claddings.
Make sure the side cladding is safely in place:
•
The locks must be connected to each
other.
•
The plate must glide into the guide of
the side cladding.
•
The side claddings must fit snugly one
inside the other (without gaps).
Fig. 7-40:
Mounting the side cladding on the spring arm
