Suspension Arm Systems Independant
50
Revision 1
WARNING
Danger of injury from falling parts!
During the installation, parts may fall.
During the installation, no-one must stand beneath the components of the suspension arm
system.
WARNING
Danger of injury from falling parts!
During the installation, no-one must stand beneath the components of the suspension arm
system.
•
Securely position the flange of the ceiling tube with spring arm
or extension arm
with spring arm
on a suitable lifting device and position under the threaded
bolts M16 of the interface plate
.
NOTICE
Position of the flange for the Duo version
The flanges have a chamfered surface to allow installation on the same height.
•
Mount the flanges in a way that the chamfered surfaces point towards each other.
•
Insert flange of the ceiling tube with spring arm
or extension arm with spring
arm
into the 6 threaded bolts of the interface plate
.
•
Remove the previously attached adhesive tape or rubber tape from the threaded bolts .
•
For each threaded bolt attach 1 plastic insulation washer as per the illustration in a
way that the retaining washer with external Ø 34 mm (see arrow in the enlarged detail
view of the illustration) sits in the plastic insulation washer .
•
For each threaded bolt use one 1 retaining washer , spring washer and
1 hexagonal nut M16
.
Components on the interface plate
:
•
Adjust the Single version, see section 7.3.3 “Adjusting the Spring Arm/Extension Arm on
the Single Interface Plate”, page 51.
•
Adjust the Duo version, see section 7.3.4 “Adjusting the Spring Arm/Extension Arm on the
Duo Interface Plate”, page 53.
