Suspension Arm Systems Independant
76
Revision 1
Mounting the canopy halves
For reasons of simplification, the illustration shows the interface plate without cables and
extension arm or spring arm.
•
Attach profile strip (not illustrated) to the
first canopy half (if desired, the canopy
can be sealed with silicone sealant).
•
Place the first canopy half on the
threaded bolts M10 x 360 mm and screw
on and tighten 3 cladding screws .
•
Ensure that the canopy halves sit flush
on the intermediate ceiling/prefabricated
ceiling.
•
If required, re-adjust the 6 threaded
bolts , see section “Preparing to mount
the canopy”, page 75.
•
Attach profile strip (not illustrated) to the
second canopy half and insert into the
first canopy half so that one is inside the
other.
•
Place the second canopy half on the
threaded bolts and screw on and tighten
3 cladding screws .
Fig. 7-34:
Mounting the canopy halves
Make sure the canopy halves / are safely in place:
•
The canopy halves / must fit snugly one inside the other.
•
The canopy must sit fully flush on the intermediate ceiling/prefabricated ceiling.
•
The 6 cladding screws must be tightened.
