KitchenAid KBFC42FS, Техническое образование

Страница: 38 / 76

4-16
10. To remove the compressor:
a) Remove the front and rear screws
from the unit compartment cover and
lift the cover off the unit compartment.
b) Insert a screwdriver into the side open-
ing of the compressor terminal cover,
pry out on the cover, and unsnap it
from the compressor.
Side Opening
Terminal
Cover
c) Disconnect the 3-pin connector from
the compressor pins (see the top right
photo).
d) Disconnect the ground wire from the
compressor terminal.
Ground
Wire
3-Pin
Connector
Terminal
Cover
Compressor
Filter-Drier
e) IMPORTANT: Refrigerant must be
handled by a licensed, EPA-certified
refrigerant technician in accordance
with established procedures. Remove
the refrigerant from the existing system
per the instructions provided with the
recovery system being used.
f) Unbraze the suction and discharge lines
from the compressor.
g) Cut the filter-drier from the system (do
not use a torch).
h) Remove the 5/16
˝
mounting bolts
from the rubber grommets of the com-
pressor.
i) Lift the old compressor off the refrig-
erator.
j) Install the new components and recon-
nect the ground wire (see top photo).
Suction Line
Discharge Line
Filter-Drier