KitchenAid KBFC42FS, Техническое образование

Страница: 59 / 76

5-5
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
WARNING
Refer to page 4-12 for the procedure for ac-
cessing the compressor and inverter.
1. Run the diagnostics tests (see page 6-2)
and check for the proper operation of the
compressor.
NOTE: If the compressor does not operate
perform the following steps.
2. Connect power to the refrigerator and al-
low it to enter the “cooling” mode.
3. While the refrigerator is in the cooling
mode, the inverter and main control board
voltages should be as shown in the chart
below.
4. Set the voltmeter to read the voltages
shown in the chart.
If the 3 to 6 volts DC is not present at the
inverter red/white and red wires, check
P7-3 and P7-8 on the main control board •
COMPRESSOR & INVERTER
for 3 to 6 volts DC. If the voltage is not
present, replace the main control board.
If the 3 to 6 volts DC is present at the main
control board, continue with step 5.
5. Unplug refrigerator or disconnect power.
6. Disconnect the wire connector going to
the compressor.
7. Set the ohmmeter to the R x 1 scale.
8. Touch the ohmmeter test leads to any two
pins. The meter should indicate approxi-
mately 6 to 7
Ω
. Check between each set
of pins to test all three windings.
9. Set the ohmmeter to the highest scale.
10. Touch one ohmmeter test lead to the
cabinet ground and the other lead to
each of the three compressor terminals.
The meter should indicate an open circuit
(infinite).
•
COMPONENT INPUT/OUTPUT LOCATIONS VOLTAGES
Inverter
Red/White & Red Wires 3 - 6 Volts DC
Black & White Wires 120 Volts AC
Main Control Board P7-3 (Red) & P7-8 (Red/White) 3 - 6 Volts DC