7/6/12
https://www.kiatechinfo.com/viewer/toc_print.asp?vehicletype=Passenger&mfrcode=KM&area=KM…
33/227
https://www.kiatechinfo.com/viewer/toc_print.asp?vehicletype=Passenger&mfrcode=KM&area=KM…
6. Reconnect the battery negative cable.
7. After installing the Passenger Airbag (PAB), confirm proper system operation:
A. Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
Restraint > Airbag Module > Side Airbag (SAB) Module > Description and Operation
DESCRIPTION
The two Side Airbags (SAB) are installed inside the driver and passenger seat and protect the driver and front
passenger from danger when side crash occurs. The SRSCM determines deployment of side airbag by using Side
Impact Sensor (SIS) signal.
Never attempt to measure the circuit resistance of the airbag module (squib) even if you are using the specified
tester. If the circuit resistance is measured with a tester, accidental airbag deployment will result in serious
personal injury.
Restraint > Airbag Module > Side Airbag (SAB) Module > Components and Components
Location
COMPONENTS
Restraint > Airbag Module > Side Airbag (SAB) Module > Repair procedures
REMOVAL
• Never attempt to disassemble or repair the airbag module.
• Do not drop the airbag module or allow contact with water, grease or oil. Replace it if a dent, crack, deformation
or rust is detected.
• The airbag module should be stored on a flat surface and placed so that the pad surface is facing upward. Do
not place anything on top of it.
• Do not expose the airbag module to temperature over 93°C(200°F).