7/6/12
https://www.kiatechinfo.com/viewer/toc_print.asp?vehicletype=Passenger&mfrcode=KM&area=KM…
20/227
https://www.kiatechinfo.com/viewer/toc_print.asp?vehicletype=Passenger&mfrcode=KM&area=KM…
2. Remove ignition key from the vehicle.
3. Disconnect the DAB, PAB, SAB, CAB and BPT connectors.
4. Remove the center console (Refer to BD group in the Service Manual).
5. Disconnect the SRSCM harness connector(A) from the SRSCM(B).
6. Remove the SRSCM mounting bolts from the SRSCM then remove the SRSCM.
INSTALLATION
1. Disconnect the negative () cable from battery and wait for at least three minutes.
2. Remove ignition key from the vehicle.
3. Install the SRSCM with the SRSCM mounting bolts.
Tightening Torque (SRSCM Mounting Bolt)
: 6.9 ~ 8.8 N·m (5.1 ~ 6.5 lb·ft)
4. Connect the SRSCM harness connector.
5. Install the center console.
6. Connect the DAB, PAB, SAB, CAB and BPT connectors.
7. After installing the SRSCM, confirm proper system operation:
A. Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
Restraint > Supplemental Restraint System Control Module (SRSCM) > Front Impact
Sensor (FIS) > Description and Operation
DESCRIPTION
The release system for the front airbag consists of a SRSCM installed in the middle of the vehicle and two front impact
sensors (FIS) which are located in front of the vehicle. Only the SRSCM is capable of releasing the airbags or the seat
belt pretensioner system in the vehicle. In the dialog between the SRSCM and the front impact sensor it is the SRSCM
which takes the release decision.