7/6/12
https://www.kiatechinfo.com/viewer/toc_print.asp?vehicletype=Passenger&mfrcode=KM&area=KM…
114/227
https://www.kiatechinfo.com/viewer/toc_print.asp?vehicletype=Passenger&mfrcode=KM&area=KM…
(5) Disconnect the SRSCM connector.
2. CHECK SHORT TO BATTERY LINE
(1) Connect the negative () terminal to the battery.
(2) Turn the ignition switch to ON.
(3) Measure voltage between the terminal 1(2) of SAB harness connector and chassis ground().
specification(voltage) : Approximately 0 V
(4) Is the measured voltage within specification?
►
Check the SAB Module.
►
Repair the short to battery line circuit on wiring harness between the SAB and the SRSCM.
3. CHECK THE SAB MODULE
(1) Replace the Side Airbag(SAB) with a new one.
● Refer to "Side Airbag(SAB)" section in this SERVICE MANUAL.
(2) Install the DAB module and connect the DAB connector.
(3) Connect the connectors of the PAB, SAB, CAB, BPT, BUPT, FIS and SIS.
(4) Connect the SRSCM connector.
(5) Connect the negative () terminal to the battery.
(6) Connect a HiScan(Pro) to the data link connector.
(7) Turn the ignition switch to ON and check the vehicle again.
Does HiScan (Pro) indicate any DTC related to Side Airbag(SAB)?
►
Go to next step.
►
Replace SAB module.
4. CLEAR THE DTC AND CHECK THE VEHICLE AGAIN
(1) Install the DAB module and connect the DAB connector.
(2) Connect the connectors of the PAB, SAB, CAB, BPT, BUPT, FIS and SIS.
(3) Connect the SRSCM connector.
(4) Connect the negative () terminal to the battery.
(5) Connect a HiScan(Pro) to the data link connector.
(6) Turn the ignition switch to ON.
(7) Clear the DTC stored in the SRSCM memory with the HiScan(Pro).
(8) Turn the ignition switch to LOCK and wait for at least 30 seconds.
(9) Turn the ignition switch to ON and wait for at least 30 seconds.
(10) Check the vehicle again with the HiScan(Pro).
Does the above DTC(s) go off?
►
Problem is intermittent or was repaired and SRSCM memory was not cleared.