Kia Sportage 2008, Руководство пользователя, Страница: 26 / 227

7/6/12 https://www.kiatechinfo.com/viewer/toc_print.asp?vehicletype=Passenger&mfrcode=KM&area=KM…
26/227 https://www.kiatechinfo.com/viewer/toc_print.asp?vehicletype=Passenger&mfrcode=KM&area=KM…
2. Install the driver's airbag on the steering wheel.
Front Passenger's Airbag :
1. Remove the glove box, then disconnect the 4P connector between the front passenger's airbag and SRS main
harness.
2. Install the SST(0957A­38100).
Buckle Pretensioner
1. Disconnect the 6p connect between the buckle pretensioner and buckle pretensioner wire Harness.
2. Install the SST(0957A ­ 2E210)
Side Airbag, CURTAIN AIRBAG:
1. Disconnect the 2P connector between the side airbag and side wire harness.
2. Install the SST (0957A­38100 : SAB, 0957A­38500 : CAB).
3. Place the deployment tool at least thirty feet (10 meters) away from the airbag.
4. Connect a 12 volt battery to the tool.
5. Push the tool's deployment switch. The airbag should deploy. Repeat for 2nd circuit if deploying DAB or PAB.
(deployment is both highly audible and visible: a loud noise and rapid inflation of the bag, followed by slow deflection)
6. Dispose of the complete airbag. No part of it can be reused. Place it in a sturdy plastic bag and seal it securely.
Deploying the Airbag Out of the vehicle
If an intact airbag has been removed from a scrapped vehicle, or has been found defective or damage during transit,
storage or service, it should be deployed as follows :
1. Confirm that the special tool is functioning properly by following the check procedure on this page.
2. Position the airbag face up, outdoors on flat ground at least thirty feet (10meters) from any obstacles or people.
Disposal of Damaged Airbag
1. If installed in a vehicle, follow the removal procedure of driver's airbag, front passenger's and side airbag.
2. In all cases, make a short circuit by twisting together the two airbag inflator wires.
3. Package the airbag in exactly the same packing that the new replacement part come in.
Restraint > Airbag Module > Driver Airbag (DAB) Module and Clock Spring > Description
and Operation
DESCRIPTION
Driver Airbag (DAB) is installed in steering wheel and electrically connected to SRSCM via clockspring. It protects the
driver from danger with deploying a bag when frontal crash occurs. The SRSCM determines deployment of Driver Airbag
(DAB) by using the Front Impact Sensor (FIS) signal. The driver airbag is two stage devices.
If the crash algorithm determines that only the first stage is to be activated, the second stage will be automatically