7/6/12
https://www.kiatechinfo.com/viewer/toc_print.asp?vehicletype=Passenger&mfrcode=KM&area=KM…
22/227
https://www.kiatechinfo.com/viewer/toc_print.asp?vehicletype=Passenger&mfrcode=KM&area=KM…
INSTALLATION
• Be sure to install the harness wire so that they are not pinched or interfere with other parts.
• Do not turn the ignition switch ON and do not contact the battery cable while replacing the front impact sensor.
1. Install the new front impact sensor with bolt then connect the SRS harness connector to the front impact sensor.
Tightening torque
: 8.8 ~ 10.8 N·m(6.5 ~ 8.0 lb·ft)
2. Install the radiator guard.
3. Reconnect the negative battery cable.
4. After installing the front impact sensor, confirm proper system operation: Turn the ignition switch ON: the SRS
indicator light should be turned on for about six seconds and then go off.
Restraint > Supplemental Restraint System Control Module (SRSCM) > Side Impact
Sensor (SIS) > Description and Operation
DESCRIPTION
The release system for the front airbag consists of a SRSCM installed in the middle of the vehicle and two side impact
sensors (SIS) which are located inside the BPillar.
They are remote sensor that detect acceleration due to collision at their mounting locations. The primary purpose of the
Side Impact Sensor (SIS) is to provide an indication of a collision. The Side ImpactSensor (SIS) sends acceleration
data to the SRSCM.
Restraint > Supplemental Restraint System Control Module (SRSCM) > Side Impact
Sensor (SIS) > Components and Components Location
COMPONENTS