7/6/12
https://www.kiatechinfo.com/viewer/toc_print.asp?vehicletype=Passenger&mfrcode=KM&area=KM…
140/227
https://www.kiatechinfo.com/viewer/toc_print.asp?vehicletype=Passenger&mfrcode=KM&area=KM…
(2) Disconnect the negative () terminal from the battery and wait for at least 3 minutes.
(3) Remove the DAB module and disconnect the DAB connector.
(4) Disconnect the connectors of the PAB, SAB, CAB, BPT, BUPT, FIS and SIS.
(5) Disconnect the SRSCM connector.
2. CHECK SHORT TO BATTERY LINE
(1) Connect the negative () terminal to the battery.
(2) Turn the ignition switch to ON.
(3) Measure voltage between the terminal 1 of SIS harness connector and chassis ground().
specification(voltage) : Approximately 0V
(4) Is the measured voltage within specification?
►
Check the SIS Module.
►
Repair the short to battery line circuit on wiring harness between the SIS and the SRSCM.
3. CHECK THE SIS MODULE
(1) Replace the Side Impact Sensor(SIS) with a new one.
● Refer to "Side Impact Sensor(SIS)" section in this SERVICE MANUAL.
(2) Install the DAB module and connect the DAB connector.
(3) Connect the connectors of the PAB, SAB, CAB, BPT, BUPT, FIS and SIS.
(4) Connect the SRSCM connector.
(5) Connect the negative () terminal to the battery.
(6) Connect a HiScan(Pro) to the data link connector.
(7) Turn the ignition switch to ON and check the vehicle again.
Does HiScan (Pro) indicate any DTC related to Side Impact Sensor(SIS)?
►
Go to next step.
►
Replace SIS module.
4. CLEAR THE DTC AND CHECK THE VEHICLE AGAIN
(1) Install the DAB module and connect the DAB connector.
(2) Connect the connectors of the PAB, SAB, CAB, BPT, BUPT, FIS and SIS.
(3) Connect the SRSCM connector.
(4) Connect the negative () terminal to the battery.
(5) Connect a HiScan(Pro) to the data link connector.
(6) Turn the ignition switch to ON.
(7) Clear the DTC stored in the SRSCM memory with the HiScan(Pro).
(8) Turn the ignition switch to LOCK and wait for at least 30 seconds.
(9) Turn the ignition switch to ON and wait for at least 30 seconds.