Keysight PD1000A, Руководство для стартапов

Страница: 22 / 108

20 Keysight PD1000A Power Device Measurement System Startup Guide
Step 2: Install System Software on Host PC
– TO_Fixture_In.xkt
— E5080A Calibration Kit file for S-Parameter
measurements. For instructions, see PD1000A Power Device Test Fixtures
for S-Parameter Measurements - Operating Guide , available at:
https://literature.cdn.keysight.com/litweb/pdf/PD1000-90005.pdf?id=29
59097
– TO_Fixture_Out.xkt
— E5080A Calibration Kit file for S-Parameter
measurements. For instructions, see PD1000A Power Device Test Fixtures
for S-Parameter Measurements - Operating Guide , available at:
https://literature.cdn.keysight.com/litweb/pdf/PD1000-90005.pdf?id=29
59097
Additional instructions for using these files are presented at different parts of this
guide.
Install S-Parameter Control Software License
All aspects of the PD1000A Control Software can be installed and used for 30
days without a license. However, after 30 days a permanent software license is
required to continue running On State and Off State S-Parameter tests. For
software and licensing information, go to:
www.keysight/com/find/PD1000A .
Other than the initial trial software license, there is one available license for the
PD1000A Control Software for S-Parameter tests:
– PD1000A-1FP -- A perpetual fixed license. This license enables the software
only on the host controller PC the license is originally assigned to; without
a time limit.
1
Once you purchase the PD1000A S-Parameter Test software license, you
can choose to receive a printed copy of an Entitlement Certificate, an email
with the certificate, or both.
2
On the host controller PC where you have installed and plan to run the
PD1000A
s oftware (you must be logged on with Administrator privileges),
log onto Keysight’s Licensing website at:
www.keysight.com/find/softwaremanager . Note, you must register if you
don’t have an account.
Ignore this section if you are not going to make On State or Off
State S-Parameter measurements. Proceed directly to “Step 3.
Setup and Run Device Characterization Tests” on page 24
You must install the Keysight License Manager software on your
host controller PC (if it was not previously installed by other
Keysight software).
www.keysight.com/find/licensemanager.