24
Keysight PD1000A Power Device Measurement System Startup Guide
Step 3. Setup and Run Device Characterization Tests
Step 3. Setup and Run Device Characterization Tests
Follow these procedures to ensure safety and to minimize the
possibility of damaging electrical components:
-
These instruments are designed for use in Installation Category
II and Pollution Degree 2, per IEC 61010 Second Edition and
664 respectively.
-
These instruments are designed for indoor use only.
-
Mains wiring and connectors shall be compatible with the
connector used in the premise electrical system. Failure to
ensure adequate earth grounding by not using correct
components may cause product damage and serious injury.
-
Use only the power cord supplied with the instruments.
Keysight power cords ensure continuity between the chassis
grounding-type power plug and the safety ground terminal at
the power outlet.
-
Install the instruments so that the detachable power cord is
readily identifiable and is easily reached by the operator. The
detachable power cord is the disconnecting device. It
disconnects the mains circuits from the mains supply to the
instrument. The front panel switch is only a standby switch and
is not a LINE switch. Alternatively, an externally installed
switch or circuit breaker (which is readily identifiable and is
easily reached by the operator) may be used as a
disconnecting device.
Содержание PD1000A
