Operators Manual
Section 5-10
When the machine reverses itself to exit the pindeck,
the screen should read:
0080 #01 IS NEXT
PDCNT 0000 FS03
The counter on the second line must read
0000
and the
failsafe will read
03
. This means the machine reversed
itself through the counter (of the lane distance sensor).
When traveling in reverse the screen may read:
0120 #01 IS NEXT
PDCNT 0002 FS00
When numbers remain in the counter (
0002
), this tells us
that the machine reversed after a signal from the failsafe
switches (
FS00
).
The machine is designed to reverse by using the counter.
The failsafe switches are a backup system ONLY! If the
machine is always reversing by the failsafe switches, the
machine may end up in the pit if they wear out.
To adjust the pindeck travel, get to the
CHANGE PROGRAM
SETTINGS
menu
and press the
NEXT
key until the screen reads:
END CLEANING
0730 DIST 0730
If the number of counts that remain are
0002
, then
decrease the Distance to End value by this number of counts
(728). Be sure to press
ENTER
otherwise the PC will not
accept the new number.
After the change is made, use the pindeck counter to
check your adjustment. When the distance is correct, the
machine will travel far enough for the squeegee to clear the
end of the pindeck and leave no moisture. The figure on the
next page shows where the machine will stop in the pindeck.
