Operators Manual
Section 2-9
E. Cleaning (Front) End Components
The following components are located under the lid on
the cleaning end of the machine:
PUMP MOTOR:
Mounted on the far left hand side of the
cleaning end is the pump motor. This motor pumps the
cleaning liquid from the supply tank through the spray
jets and onto the lane surface.
VACUUM MOTOR:
Located on the right side is the vacuum
motor. This motor is used with the squeegee assembly and
recovery tank to vacuum the cleaner off the lane. This
motor needs special attention in high dirt areas,
especially if the gutters and caps are not dusted
regularly.
SUPPLY TANK:
The tank nearest the left side is the
cleaner supply tank. This tank will hold enough cleaner
to completely clean in excess of 20 lanes. A screen
filter is located inside the tank.
RECOVERY TANK:
The tank nearest the right side is the
recovery tank. This tank will hold over 20 lanes of used
liquid without needing to be emptied.
DMR DUSTER/CLEANING CLOTH ASSEMBLY:
Mounted inside and
across the entire front end is the DMR Duster Cleaning
Cloth Assembly. Two motors, one located on each side,
move the cloth from one core to the next. The gear motor
on the left side is called the
UNWIND MOTOR
. When
operated it will let out new cloth from the supply roll.
The gear motor on the right side is the
WIND-UP MOTOR
.
When operated it will wind up the used, dirty cloth on
the white PVC take up roller.
For best results, use
Kegel Kloth
(Part #153-0047K) or you
can use DBA #8460 or Lane DynamX #9460 Lane Cleaning
Cloth (or other equivalent). The machine will use
approximately 1-1/2" of cloth per lane.
*
DBA #8460 is a registered trademark of DBA Products Co., Inc.
*Lane DynamX #9460 is a registered trademark of Lane DynamX. Not
affiliated with The Kegel Company, Inc.
