Operators Manual
Section 1-2
C. Care and Safety Procedures
This machine is manufactured of the highest quality
materials, but keep in mind that this is a sensitive piece
of equipment. Care should be taken to see that it is not
dropped, knocked around, or handled roughly.
Doing so may damage the programmable computer, its
components, the conditioner transfer system, the Duster
assembly, or the vacuum cleaning and squeegee system.
For care and safety reasons, follow these precautions:
Avoid spilling any liquids or chemicals inside of the
machine.
Do not operate the machine with an extension cord or
power cord other than the one provided.
Make sure that the power outlet used provides the correct
voltage and amps. It must be a clean circuit with no
other loads on it.
Do not attempt to make any wiring modifications.
Do not attempt to re-program the computer.
Do not operate the machine in an upright position.
Always empty the recovery tank before standing the
machine up and transporting it. Failure to empty the
tank will cause the dirty cleaner to either spill out
through the vacuum motor or out of the squeegee when
going over ramps. Then the next time the machine is
started, it will blow cleaner out of the vacuum exhaust.
Not following the above recommendations may cause
damage to the
machine, its computer, persons operating it,
or void the warranty.
Persons assigned the responsibility of operating this
equipment should be trained in its use by an authorized
factory-trained Distributor.
