Katronic Technologies FLUXUS ADM 6725, Руководство по эксплуатации

Страница: 125 / 148

Process Interfaces
ADM 6725 E10

KA T
13 - 3
13.1.2 Set-up of Current Loop
Note: The display 'Current Loop' only appears in program branch OPT if FLUXUS is
equipped with a current loop, which has been installed in program branch SPECIAL
FUNCTIONS (see chapter 7.7.5).
no >YES<
Current Loop
O12
Select YES , if you wish to activate the current
loop analogue output.
13.1.3 Set-up of Voltage Output
Note: The display ‘Voltage Output’ only appears in program branch OPT if FLUXUS is
equipped with a voltage output, which has been installed in program branch
SPECIAL FUNCTIONS (see chapter 7.7.5).
no >YES<
Voltage Output
O25
Select YES , if you wish to activate the
analogue voltage output.
13.1.4 Set-up of Frequency Output
Note: The display 'Frequency Output' only appears in program branch OPT if FLUXUS is
equipped with a frequency output, which has been installed in program branch
SPECIAL FUNCTIONS (see chapter 7.7.5).
no >YES<
Frequency Output
O14
Select YES , if you wish to activate the
analogue frequency output.
13.1.5 Set-up of the Full-Scale Value for all Analogue
Outputs
FLUXUS will display the unit of measurement (m3/h, in our example) according to the
previously selected quantity of measurement (in this case: volume flow).
0.1 m3/h
Full-Scale Val.
O13
b
O15
b
O26
b
This display requires the input for the full-scale
value of the respective analogue output. Specify
as 'Full-Scale Val.' the highest measuring value,
which can be expected. The entered parameter
for the full-scale value would correspond to 100 %
of the measured value = 20 mA, 1 V or 10 V,
1000 Hz.