Karel DS200, Техническое справочное и монтажное руководство

Страница: 152 / 222

142
do not carry it. In that case, another attempt to hang the exchange on the holders should
be performed again. Before the exchange is released, it should be shaken gently to the
right and left to check whether the wall mount bars actually carry it, in order to make sure
that the exchange has thoroughly been fixed on the wall.
9- In case it is necessary to remove the exchange from the wall, it suffices just to lift it
upwards cautiously and pull it out.
*
KEEP IN MIND THAT IT IS ESSENTIAL TO MOUNT AND DISMOUNT
THE WALL MOUNT BARS SIMULTANEOUSLY; OR THEY MAY BE
DEFORMED.
10- If SPS200S has been removed in order to facilitate the installation, then it is replaced as
explained in detail later in the guide.
11- The 230 VAC cable is attached to the corresponding input on SPS200S. Before plugging
the other end of the cable into the outlet, the statuses of on/off switches and soundness
of fuses must be checked. The mains on/off switch must be off. Keep in mind that the
battery on/off switch must be set to “on” after the mains supply is on and it must be set to
“off” before the mains is shut off.
Two 2A T-type fuses that are required for 230 VAC are present in the drawer-type
compartment next to the 230 VAC input.