Fuse and Bulb
106
There is pressure in the bulb and it may explode when it is
replaced, so please prevent injury as repairing.
The bulb will be very hot when it is operating or just after it
goes out, so please wait until the bulb cools down to replace it.
When replacing bulb, please take care to prevent sharp edges
(including the sharp edges of lights and the sharp edges of
adjacent vehicle parts) from causing injury.
Caution!
Before performing any work on electronic equipment, it is
necessary to remove the ignition key to avoid short circuit
danger!
Turn off the lights before replacing the bulb.
Please replace the bulb carefully to prevent damage to any
parts.
It is easy to damage the paint during disassembly. Therefore, it
is still recommended to replace the bulb by professional
personnel.
Instruction
Please place the removed components on cloth or plastic foam to
prevent any scratch or damage to components as putting them
down.
Please check and operate regularly. Ensure that the function of
all illumination equipment on vehicle is kept in well condition,
especially for exterior illumination. This is good for your own
safety and the safety of other road users.
Before replacing the bulb, please prepare the relevant
replacement bulb.
Never hold the bulb by bare hands. Wrap it with fabric or
paper products and hold it, or fingerprints will be left on the
surface of bulb. These fingerprints will heat up and forming
dirt, effecting light brightness.
