Drive
44
key into the ignition switch.
③
Sep on the brake pedal and turn the mechanical key to ACC
gear (at this time, the vehicle lights can start to work).
④
Then, turn it to “ON” gear to initiate the vehicle completely
( “ready” indicator light on the meter is lit).
⑤
Put the shift lever on “D” (Drive) or “R” (Reverse) gear,
release the handbrake, then the brake pedal, and the vehicle
can begin to run. check and confirm the reset parking brake.
Warning !
When the vehicle is initiated, make sure to be seated in the
driver’s seat. do not step on the accelerator pedal when the
vehicle is initiated under any circumstances. Otherwise, it may
cause an accident, resulting in a serious injury or even death.
If an emergency occurs during driving and it is necessary to
make the vehicle stop, you must turn on the hazard alarm
light for the first time and try to park it at the roadside as
soon as possible under the safety is guaranteed.
Instruction
Note: If the mechanical key is turned to the “ON” position, the
“ready” indicator on the instrument fails to light up, indicating
that the vehicle has not been started successfully. Check whether
the gear shifter is in the “N” position and whether the brake is
applied during ignition Re-ignite after pedaling. If all the above
are normal and the ignition cannot start normally after several
ignitions, the vehicle needs to be inspected and repaired.
Park the Wheel
Turn the mechanical key to “ACC” gear to drive the electric
motor stop working. and turn the mechanical key to “LOCK” gear
to drive the vehicle's electrical appliances stop working.
Warning !
Do not turn the mechanical key to “ACC” gear or “LOCK”
gear suddenly when driving the vehicle.
If the torque required to turn the steering wheel increases
after the mechanical key is turned to “LOCK” gear, it is likely
to cause an accidents due to untimely rotation of the steering
wheel.
Please pull up the handbrake after the vehicle has stopped.
Driving
−
Step on the brake pedal, place the shift lever on “D” (Drive)
gear or “R” (Reverse) gear, () (the meter gear is stable on
“D” gear or “R” gear and the indicator light does not flash
any more), release the brake and it is no need to step on the
electronic accelerator pedal, the vehicle can start idling. if
necessary to accelerate, just step on the accelerator pedal
with your right foot.
If the shift lever is placed in “D” (Drive) gear or “R” (Reverse)
gear, “D” gear or “R” gear displayed on the meter continues to
flash, it indicates that the gear shift is unsuccessful and it is
necessary to step on the brake pedal and shift the gear again. If the
