MULTICAL® 803
Kamstrup A/S · Technical description · 5512-2360_A1_GB_02.2019
81
TECH loop
Display
Primary display
Secondary display
Index
number in
display
Logging
depth/Refere
nce number
301
Info Module 3 Config no.
6
2-301-00
N
o
31
301.x Firmware revision
7
2-301-xx
N
o
32
301.x Module serial number
7
2-301-xx
N
o
33
301.x Primary address
7
2-301-xx
N
o
34
8
301.x M-Bus secondary addressing
7
2-301-xx
N
o
35
8
301.x M-Bus enhanced secondary addressing
7
2-301-xx
N
o
36
8
301.x KM-RF frequency
7
2-301-xx
N
o
37
301.x KM-RF network address
7
2-301-xx
N
o
38
401
Info Module 4 Config no.
6
2-401-00
N
o
31
401.x Firmware revision
7
2-401-xx
N
o
32
401.x Module serial number
7
2-401-xx
N
o
33
401.x Primary address
7
2-401-xx
N
o
34
8
401.x M-Bus secondary addressing
7
2-401-xx
N
o
35
8
401.x M-Bus enhanced secondary addressing
7
2-401-xx
N
o
36
8
401.x KM-RF frequency
7
2-401-xx
N
o
37
401.x KM-RF network address
7
2-401-xx
N
o
38
1
Depending on the selected depth of yearly and monthly logs in the programmable data logger, these display
readings can be empty.
2
The temperature average is volume-based.
3
The date of min./max is displayed in the format 20xx.xx.xx. By serial reading, the time (hh.mm) is included too.
4
Inputs A1, B1 A2 and B2 are updated continuously in the display of MULTICAL® 803, i.e. the display of the connected
water or electricity meter will be in accordance with the display of MULTICAL® 803 without delay.
5
The unit of this reading is fixed at kW. The reading is updated at the same speed as the integration interval, which is
determined by the L code.
6
This reading is fixed under module info.
7
These readings depend on the module and are thus not fixed readings. The order of the readings can vary depending
on the module. That is why the index number is set to “xx”.
8
For module 60 - LON FT-X3, the reference numbers 34, 35 and 36 will be used for displaying the module’s neuron ID
divided into three parts. The module’s neuron ID is displayed in decimal format on the display. The read values must
be converted from decimal to hexadecimal for use in the LON system.
9
The module number is automatically updated when the modules are replaced. If slot M1, M2, M3 or M4 is
deenergized, for example during backup operation, the two-digit number of each module slot shows 99 in the display
to indicate that the communication with any module on a given module slot is not possible.