
Ultrasonic Diagnostic Instrument (Vet)
User’s Manual V1.01
- 8 -
5.2.1 Ultrasonic probe connection
1. Turn off the system, insert the probe connector into the probe interface on the right of the main unit.
Note the direction of D-head
.
2. Rotate the two probe locking knobs clockwise and lock them.
5.2.2 Ultrasonic probe disconnection
Turn off the system, and then rotate the locking knobs counterclockwise, pull out the probe
connector vertically.
5.3 Install/Remove the battery
1. Install the battery
Turn off the system; remove the battery cover on the back of main unit, put the battery into the
battery storage correctly, and then install the battery cover.
2. Remove the battery
Turn off the system; push the "Battery-cover buckle" on the battery cover on the back of main unit,
remove the battery cover, pull the strap on the battery and take out the battery.
5.4 Shutter release installation
Install shutter release to foot switch port as shown in the figure.
5.5 Video recorder installation
1. Turn off the system, connect the equipotential terminal ( ) of the video recorder to the earthing;
2. Connect one end of the video connection line to the video recorder and the other end to the Video
output port on the right of main unit;
3. Insert one end of power plug (jack) of the video recorder to the power input socket of the video
recorder, the other end to the power supply socket.
Warning:
Before connecting or using the probe, make sure that the probe, connecting
cable and connector are in normal condition (free of cracks or drop). Use of defective
probe may cause electric shock.