TH-A9
1-11
Prior to performing the following procedure, remove
the left and right side covers.
Also remove the DVD door.
Also remove the front panel assembly and DVD
mechanism base.
Disconnect the card wires from the connectors
CN401 and CN402 on the analog board.
Remove the screw (I) that retains the analog board
bracket from the top of the unit.
Remove the screw (J) and the screw (K) that retain
the analog board from the rear panel of the unit.
Disengage the analog board bracket and the gear
motor assembly by moving the engaged part (b)
upward. Then move the analog board in the direction
of the arrow, and remove it as if pulling it out of the
rear panel.
Remove two screws (L) that attach the analog board
to the analog board bracket.
Removing the analog board
(See Figs.12 to 14)
1.
2.
3.
4.
5.
Prior to performing the following procedure, remove
the left and right side covers.
Also remove the DVD door.
Also remove the front panel assembly and the DVD
mechanism base.
Remove the three screws (M) that retain the tuner
assembly, from the rear panel of the unit.
Disconnect the card wire from the connector CN1 on
the tuner assembly.
Removing the tuner assembly
(See Figs.12 and 13)
1.
2.
Fig.12
Fig.13
Fig.14
Analog board
CN401
Analog board
CN1
Tuner assembly
I
Analog board bracket
Engaging
point (b)
Analog board
CN402
Tuner assembly
CN1
Analog board bracket
CN402
Analog board
CN401
J
K
M
Engaging point (b)
Analog board
L
L
Analog board bracket
