Juniper NSM4000, Руководство по оборудованию

Страница: 88 / 196

This section provides instructions for configuring NSM appliances for SNMP monitoring.
You must provide access credentials for the SNMP server, a list of IP addresses from
which logon requests will be accepted, and the trap conditions to be reported to the
SNMP server.
To configure SNMP monitoring of your NSM4000 appliance, select System Administration
> SNMP Monitoring . The SNMP window appears. This window contains the tabs described
in the following sections:
• SNMP Configuration on page 74
• SNMP System Information on page 75
•
SNMP Trap Configuration on page 75
SNMP Configuration
To configure SNMP:
1.
Select
System Administration
>
SNMP Monitoring
.
2.
Select the
SNMP Config
tab, which is shown in Figure 34 on page 74 .
Figure 34: Configuring SNMP
3.
Select the version of SNMP to be used, either v2c or v3.
4.
Provide authentication information:
•
If you selected SNMP v2c, enter a username.
•
If you selected SNMP v3, enter a username and password.
The password must be at least 8 characters long.
The NSM4000 appliances implement a single username and password, which is
effective only for SNMP communication and is not related to any other username
and password used on the NSM4000 appliance.
5.
To limit SNMP Get requests to specific servers, select
Only
, and then enter the IP
addresses of the permitted servers.
6.
Click Save .
Copyright © 2016, Juniper Networks, Inc. 74
NSM4000 Appliance Hardware Guide