Jungheinrich DFG 425, Руководство по эксплуатации

Страница: 53 / 103

0106
.GB
E 18
4.7 Starting procedure for the TFG
F
Note the safety regulations for handling
liquid gas (see Chapter D, section 1).
– Slowly open the shutoff valve on the
LPG bottle.
– Put the key in the ignition / starter
switch (19).
– Set the ignition / starter key (19) to the
“ I ” position.
– Press the warning switch (26) and test
the horn.
The charging current (3), motor oil
pressure (2), neutral setting (14) and
parking brake (5) indicators light up.
– Gently apply the accelerator pedal
(21).
– Set the ignition / starter key now to the
II position.
M
Only apply the starter for a maximum
of15 seconds without interruption.
Before starting again, wait 30-60
seconds and reset the ignition / starter
switch to
0 .
– Release the key as soon as the motor
starts. It automatically returns to the I
position.
F
When working with LPG trucks it is
essential to always observe the
following safety regulations.
If a truck will not start:
– Close the gas bottle shutoff valve.
– Turn off the ignition / starter
O .
– Call for a trained, authorised customer service engineer.
M
All indicators lights except for neutral setting (14) and parking brake (5) should go out
as soon as the motor starts. If not, stop the motor immediately and rectify the fault.
19 21
26
27
14
3 5
2
0106
.GB
E 18
4.7 Starting procedure for the TFG
F
Note the safety regulations for handling
liquid gas (see Chapter D, section 1).
– Slowly open the shutoff valve on the
LPG bottle.
– Put the key in the ignition / starter
switch (19).
– Set the ignition / starter key (19) to the
“ I ” position.
– Press the warning switch (26) and test
the horn.
The charging current (3), motor oil
pressure (2), neutral setting (14) and
parking brake (5) indicators light up.
– Gently apply the accelerator pedal
(21).
– Set the ignition / starter key now to the
II position.
M
Only apply the starter for a maximum
of15 seconds without interruption.
Before starting again, wait 30-60
seconds and reset the ignition / starter
switch to
0 .
– Release the key as soon as the motor
starts. It automatically returns to the I
position.
F
When working with LPG trucks it is
essential to always observe the
following safety regulations.
If a truck will not start:
– Close the gas bottle shutoff valve.
– Turn off the ignition / starter
O .
– Call for a trained, authorised customer service engineer.
M
All indicators lights except for neutral setting (14) and parking brake (5) should go out
as soon as the motor starts. If not, stop the motor immediately and rectify the fault.
19 21
26
27
14
3 5
2