JST AP-K2, Руководство по эксплуатации

Страница: 20 / 36

H:\0 - Quality Documents\2 Department\Tech Serv\Application tooling\Presses\AP-K2\TS009-02 AP-K2 Operation Manual.doc
20
6.3 Positioning of the Solenoid Bracket
Once a year remove the cap head screw from the
catch on the belt cover and open the cover.
Check that the clearance is correct as shown on the
photograph.
The clearance should be 10-11mm, if it varies from this
dimension adjust the bracket in the following manner:-
Loosen the two cap head screws holding the bracket
to the press casting and move the solenoid up or down
until the correct clearance is obtained.
Tighten the cap head screws on the retaining bracket,
close the belt cover and replace the socket screws in the
bracket.
Clearance 10 - 11mm