JST AP-K2, Руководство по эксплуатации

Страница: 12 / 36

H:\0 - Quality Documents\2 Department\Tech Serv\Application tooling\Presses\AP-K2\TS009-02 AP-K2 Operation Manual.doc
12
4.2 Inspection before operation
IMPORTANT
Ensure that the hand crank has been removed before commencing.
Ensure the correct fitting of the guards.
4-3. Operation under power
Step 1
Connect the power supply cable and the foot-
switch cable to the control box using the screw in
connectors. Connect the power supply cable to the
mains supply and switch on the press.
CAUTION
Ensure that the power supply cable is routed from
the press safely and does not become trapped or
chafed by any part of the crimping machine.
Step 2
Turn ON the light by the rotary switch as shown
below.
Step 3
Turn the power switch ON; you will hear the fly-wheel
start to turn.
Step 4
Position a wire over the terminal and press the foot-
switch once to activate it. The terminal is crimped and
the next terminal is indexed along over the anvils
ready for the next operation.
CAUTION
If any problems occur during operations, immediately press the Power Off push-button and investigate the reason If the problem
requires the removal of safety guards, contact a person authorised to remove the guards. ON NO ACCOUNT REMOVE SAFETY GUARDS
IF YOU ARE NOT AUTHORISED TO DO SO.